The sliding bearing is in contact with the surface, so a certain oil film should be maintained between the contact surface. Therefore, the following problems should be paid attention to in the design:
1, to make the oil film can smoothly enter the friction surface.
2. Oil shall enter the bearing from the non-bearing surface area.
3, do not make the whole ring groove in the middle of the bearing.
4, such as oil tile, the joint opening oil groove.
5, to make the oil ring oil fully reliable.
6. Do not plug the refueling hole.
7. Do not form an oil stagnant zone.
8. Prevent sharp edges and edges of cutting oil film.
CATEGORIES
Latest news
- 139th Canton Fair
- WB Bush
- Washer Thrust Pom Bushing Tin Or Coppe
- SF-1T CARBON STEEL GEAR PUMP SELF-LUBR
- SF-1 PAP TEFLON BUSHES PAF PAS P10 P20
- POM Bushing
Contact us
- ADD: No.426,Hunan International Commerce Center, Jintai Square,Changsha 410001,Hunan
- TEL: 86-731-84770162
- FAX: 86-731-84770163
- E-mail: susan@slide-bearing.com
> Industry news